1.When the technician is debugging the mold, only one person can debug it, not two people.

2. When the machine is not in production, the power should be cut off in a timely manner.

3. When short workpieces are needed, special tools should be used and direct feeding or picking up by hand is not allowed.

4. It is strictly prohibited to wear gloves when drilling and milling machines; When using the grinder, wear a mask and eye protection to protect yourself.

5. Pay attention to dragging the mold to prevent it from falling off the ground (the flatbed truck needs to be lowered to transport the mold).

6. After adjusting the machine for high impact and normal stamping, close the sound isolation box

7. When stamping iron sheets, wear gloves and concentrate to avoid hand injuries.

8. During work, first check if there are any abnormalities in the operation of the equipment, such as unclear single or continuous punching, ineffective operation, or electrical faults. Immediately shut down the machine and seek timely assistance from the technician on duty.

9. When adjusting the machine, it is necessary to adjust the machine to single action, and it is strictly prohibited to connect the discharge belt.

10. Conduct equipment inspection according to the inspection content on the equipment inspection card, paying special attention to whether the guiding and braking devices of the punching machine operate normally, and the single and continuous punching functions are clear.

11. When packing materials, waste materials, and molds, gloves should be worn to avoid scratching hands.

The information comes from the internet. If there is any infringement, please inform us to delete it.